Geometric Extrusion Coater Laminator

  Used Geometric Laboratory (Pilot) Extrusion Coater Laminator, equipped with 18" cantilever-mounted single position primary and secondary unwinds (3" lug-type air shafts, Montalvo air brake, constant tension control system, manual sidelay), two (2) driven rubber-covered "S" wrap pull rolls, universal coating station (reverse gravure, direct gravure, offset gravure, differential offset gravure, 3-roll reverse pan & nip fed, 3-roll differential nip fed, 4-roll differential nip fed)U>, 10' arch type dryer (350 degrees F), Fife pivot edge guide, extrusion laminator, Una-Dyn 300# capacity hopper, two (2) Killion model KN-150 1.5" extruders with four barrel heat/cool zones each, one (1) model KN-175 1.75" extruder with four barrel heat/cool zones, Eurotherm model 808 digital temperature controllers, co-extrusion feedblock (A-B-C configuration, A:30%, B:40%, C:50%), 24" Masterflex Model LD-40 cast film extrusion die, slitting station, 18" maximum diameter single position cantilever mounted rewind (3" diameter lug-type air shafts, 6" core adapters), 5-motor Westamp DC servo drive system with Peerless motors and tach feedback speed control.P>